The thermal resistance formula is in the form of Rt=Ro(1+A*t+B*t*t);Rt=Ro[1+A*t+B*t*t+C(t-100)*t*t*t], t represents Celsius temperature, Ro is the resistance value at zero degrees Celsius, أ, B, C are all specified coefficients, for Pt100, Ro is equal to 100℃.
A PT100 sensor acquires temperature by measuring the change in its electrical resistance, which directly correlates to the temperature it is exposed to; as the temperature increases, the resistance of the platinum element within the sensor also increases, allowing for a precise calculation of the temperature based on this resistance change; essentially, ال “100” in PT100 signifies that the sensor has a resistance of 100 أوم عند 0 درجة مئوية, and this value changes predictably with temperature fluctuations.
Platinum resistors are widely used in the medium temperature range (-200～650℃). في الوقت الحالي, there are standard temperature measuring thermal resistors made of metal platinum on the market, such as Pt100, Pt500, Pt1000, إلخ.
The temperature measurement range of the commonly used platinum resistance Pt100 sensor probes is -200～850℃, and the temperature measurement ranges of Pt500, Pt1000 sensor probes, إلخ. are successively reduced. Pt1000, temperature measurement range is -200～420℃. According to the IEC751 international standard, the temperature characteristics of the platinum resistor Pt1000 meet the following requirements:
The DS18B20 sensor communicates using the “1-سلك” protocol, which means it uses a single data line for all communication with a microcontroller, allowing multiple sensors to be connected on the same line and identified by their unique 64-bit serial code; this single data line is pulled high with a resistor and the sensor transmits data by pulling the line low during specific time slots to send bits of information.
This article explains in detail the application of custom DS18B20 digital temperature sensor in building a digital thermometer. Including working principle, hardware connection, software programming and simulation implementation. Provide complete protues simulation diagram, C source code and result analysis to help readers deeply understand and practice the use of DS18B20.
What are thermistors NTC and PTC?
NTC and PTC are both thermistors, which are special resistors that can change resistance with temperature. They can also be said to be a kind of sensor.
Q: Can you explain sensitivity resolution in more detail? Why are higher values better?
أ: High sensitivity eliminates any lead resistance. It also simplifies the supporting electronics. أ 10,000 ohm thermistor changes resistance by 4.4% أو 440 ohms for a 1°C change in temperature. أ 100 ohm platinum sensor changes resistance by 1/3 ohm for a 1°C change in temperature.
Comparison between PT100 temperature sensor probe and DS18B20 module
1) Basic principle of signal acquisition
① The resistance of PT100 changes proportionally with the temperature (the higher the temperature, the greater the resistance), but the resistance change is very small, about 0.385 أوه / degree;
English
العربية
Български
粤语
中文(简体)
中文(漢字)
Nederlands
Suomi
Français
Deutsch
Ελληνικά
Magyar
Italiano
日本語
한국어
Polski
Português
Română
Русский
Slovenščina
Español
Svenska
ภาษาไทย
Türkçe
Tiếng Việt