Posts by Administrator
Car Engine Coolant Water Temperature Sensor
How does the car reflect the temperature of the car engine coolant? It is through the water temperature sensor, which is also called the water temperature sensor plug. So where is the specific location of the car water temperature sensor? The water temperature sensor enables the control unit to identify engine overheating or an unusual rise in temperature. How much does a car water temperature sensor cost?
Principle and temperature measurement range of NTC thermistor
DS18B20 temperature sensor connected to MCU
DS18B20 is a commonly used digital temperature sensor. It outputs digital signals, has the characteristics of small size, low hardware overhead, starke Anti-Interferenz-Fähigkeit, hohe Präzision, and is widely used.
Design of DS18B20 Digital Temperature Sensor for STM32
DS18B20 is a digital temperature sensor that uses a single bus timing to communicate with the host. Only 1 Wire is needed to complete the temperature data reading;
DS18B20 has a built-in 64-bit product serial number for easy identification. Multiple DS18B20 sensors can be connected to 1 Draht, and through 64-bit identity authentication, the temperature information collected from different sensors can be read separately.
Design of temperature measurement function of digital temperature sensor DS18B20
DS18B20 Digital Temperature Sensor Connect Arduino
Today I will show you how to use the DS18B20 digital temperature sensor with an Arduino so you can measure the temperature of air, liquids such as water, and the ground.
To connect the DS18B20 digital temperature sensor to Arduino, you need to do the following steps:
Hardware connection:
Connect the VCC pin of DS18B20 to the 3.3V power pin of Arduino.
Connect the GND pin of DS18B20 to the ground pin of Arduino.
Connect the data pin of DS18B20 to the GPIO pin of Arduino (Zum Beispiel, GPIO4).
Connect a 4.7kΩ pull-up resistor between the data pin and the 3.3V power pin.
Auswahl und Anwendung von NTC-Thermistorsensoren | Hohe Genauigkeit und Präzision
Hochpräzise und präzise NTC-Thermistorsensoren werden in verschiedenen Branchen eingesetzt, von medizinischen bis hin zu industriellen Anwendungen. Die medizinische Industrie verlässt sich in verschiedenen Anwendungen, einschließlich Kathetern, auf NTCs, Dialysegeräte, und Patientenüberwachung. Dieses medizinische Sensorteil ist 1355 Ohm bei 37°C mit Beta 25/85 von 3976.
NTC-Thermistorsensor Temperaturmessung mit NTC-Schaltkreis
PT100/PT1000-Temperaturerfassungsschaltungslösung
Metallische Wärmewiderstände wie Nickel, Kupfer- und Platinwiderstände haben eine positive Korrelation mit der Widerstandsänderung mit der Temperatur. Platin hat die stabilsten physikalischen und chemischen Eigenschaften und wird am häufigsten verwendet. Der Temperaturmessbereich des häufig verwendeten Platinwiderstands Pt100 beträgt -200 bis 850 °C. Zusätzlich, Die Temperaturmessbereiche von Pt500, Pt1000, usw. werden sukzessive reduziert. Pt1000, Temperaturmessbereich -200~420 ℃. Gemäß der internationalen Norm IEC751, Die Temperatureigenschaften des Platinwiderstands Pt1000 erfüllen die folgenden Anforderungen: