중국 맞춤형 제한 디스크 온도 조절기 제어 스위치 Therm o-Disc

스냅 디스크, 또는 3/4″ Limit switch thermostats are bimetal mechanical thermostats that function via the thermal expansion and contraction of a bimetal disc that “snaps” from a convex to a concave shape at a set temperature. 최대 AC 110V/400V 운반, 10A-60A 암페어-240볼트.

L150-20 히터 제한 온도 조절기 열디스크 개방 시 상승

KSD302 SHL120 가열 제한 온도 조절기 플랜지 플레이트 어댑터가 포함된 열디스크

KSD302R-453 Normally Open/Manual Reset 3/4″ Snap Disc Limit Control Switches

Limit Disc Thermostat Control switches are the same for different stoves, Electric ovens, electric water heaters, 전기 히터, 가전제품, 모터, refrigeration or heating equipment. so to replace it cheap you just have to understand their function.

Why are they called Snap Discs Limit Thermostat is because they are round like a disc and have a Bi-Metal Strip that Snaps when heated to a certain temperature!

Most Limit Disc switches are SPST Thermostat single pole single throw. This means one wire in and one wire out. So when the temp rises the wires are connected which means the switch is closed ( Equipment power outage ).

It will also keep the fans running after the Electric oven / electric heater has been manually or automatically turned off until the exhaust temperature cools down. Unless it is like the Disc Thermostat which has another identical switch just like it to keep the fans running. Sometimes they have a part number with a designation F for Fan or L for Low Limit but don’t be fooled they are the same type of switch! After all you can test it with a continuity checker or ohm meter. When the switch is cold the meter should read open or infinity on the ohms scale and when heated above 140 Degrees F the switch will close and read a short or no ohms Usually a bad low limit switch means the Electric oven, electric heater stops running after the 15-20 min Electric oven, electric heater start-up cycle.

Also the part numbers for each Electric oven, electric heater manufacturer may differ.
Since most open when the exhaust temp drops below 140 degrees f the part number may be called L140 Also they close when the exhaust temp rises above 140 degrees f or 150 degrees f so they may be called F130 or F160 Let’s get real here folks these Limit Disc switches are not fully digital with precise accuracy!! 그래서 130 또는 160 may be within the specs of the bi-metal strip inside meaning there are the same switch!!

So in the pic here below is one that I found cheap. Note the physical mounting is usually the same with the mounting holes 2 inches apart. Most Electric oven, electric heater have a male quick disconnect terminal but some Electric oven, electric heater like YAXUN who make their own switch have screw terminals. However the screws can be removed and a clip can go on it but they do charge more for the extra unnecessary hardware!!

애플리케이션: 용접 기계와 같은 대규모 전력 부하가있는 전기 장비 및 가정 기기에 적용 가능, 온수기, 히터, 전기차 배터리, 세탁기, 냉장고, 위생 도자기 온도 조절기, 등.

1. 전기 매개 변수: 1) CQC, VDE, UL, 컬. AC250V 50~60Hz 5A / 10ㅏ / 15A ~ 60A (저항 부하).
2. UL AC 125V 50Hz 15A (저항 부하).
2. 작동 온도 범위: 0~ 240 ℃ (선택 과목).
3. 회복 및 작동 온도 차이: 8~100℃ (선택 과목).
4. 배선 방법: 플러그 터미널 250# (선택 0~90°를 구부리십시오); 플러그 터미널 187# (선택 0~90°를 구부리십시오, 두께 0.5, 0.8MM 선택 사항).
5. 전기 강도: 1 분의 AC 50Hz 1800V, 깜박임이 없습니다, 고장 없음.
6. 연락 양식: 상시 닫힘형: 온도가 상승하다, 연결 해제에 문의하십시오, 온도 감소, 연락처 연결; 상시 개방형: 온도가 상승하다, 연락처 연결, 온도 감소, 연결 해제에 문의하십시오.
7. 쉘 보호 수준: IP00.
8. 접지 방법: 온도 조절기의 금속 껍질을 통해 장치의 접지 금속 부분에 연결됨.
9. 설치방법: 움직일 수있는 링이있는 KSD302 시리즈, 고정 반지, 마운팅 플레이트 이동식 링, 장착 구멍이있는 일반 스테인레스 스틸 커버.
10. 온도 작동 범위: -32℃∽+320 20.