Ksd9700 온도조절기 N.C 5A / 10바이메탈 온도 조절 스위치

KSD-9700 series 5A, 10ㅏ, 16ㅏ, 20ㅏ, 25ㅏ, 40ㅏ, AC 250V 50～60Hz thermostat thermal protector action switch consists of dish shape high sensitive bimetal elemeng, movable contact-head, static contact-piece, soleplate, outer case, ghermal resistant lead and so on. 바이메탈 디스크는 자유 상태에 있으며 전기 제품이 정상 상태에서 작동할 때 접점이 닫힙니다.. 주변 온도가 사전 설정된 작동 온도까지 상승한 경우, 바이메탈 디스크가 가열되면 점프하도록 변형되면서 접점이 열립니다., 그런 다음 온도를 제어하기 위해 회로가 차단됩니다. 전기 제품이 재설정 온도로 냉각되면 접점이 자동으로 닫혀 회로가 차단됩니다.. The bimetallic element restores to its primary state and contact point is closed . The electric appliance restores its work. The product has many advantages such as small in resistor, puick in temperature feeling, fast in action. Safe and reliable. compact and so on. This product is widely used in home appliance’s motor and electrical equipment, such as air conditioner motor, 변신 로봇, 열기구, 등.

KSD9700 바이메탈 열 보호 스위치

KSD9700 5A 10A 250V Thermal Cutoff Thermostat

KSD9700 Temperature Switch 5A 250V N.O. NC

명세서
정격전압: AC 250V 50～60Hz
정격전류: 5ㅏ, 10ㅏ, 16ㅏ, 20ㅏ, 25ㅏ, 40A of Resistive Load
Switch Type and Number of poles: 1 pole opener
IP-Protection Degree: IP00
작업 유형: 1ㅏ
운영주기: 10000 cycle
Insulation material PTI value : 175V
Resistance of Contact: ≤ 50mΩ (original state)
Resistance of Insulated : >100MΩ(DC500V normality)
Test Voltage : ≥ 1250V/1min(nomality)
1 또는 2 Temperature Control Switch
모델 : KSD9700
재료 : 금속 케이스
연락하다 : 체크 안함(Normal Closed)/아니요(Normal Open)
온도 : 15°C~155°C
정격 출력 : 250V 5A
Lead Wire Length : 7.3cm / 2.9″
머리 치수 : 20 엑스 7.5 x 3.5mm/0.78″ x 0.3″ x 0.14″(L*W*T)

Precautions for use:
1. Do not deform or collapse the casing during installation!
2, this product is not suitable for use in the air temperature, only for contact temperature!
(Can be fixed by tie wire, iron wire, fixing seat or 704 silicone rubber)
3, the metal case is charged, not suitable for working in water.
The plastic case should not be immersed in the insulating seal when it is placed in the water.
4. When the product is installed, the temperature control switch should be close to the mounting surface of the controlled appliance.