SET Square TCO thermische zekering gebruik steiltang

Square shell type thermal fuse:
A fusible alloy wire is connected between the two pins of the thermal fuse, and the fusible alloy wire is coated with a special resin, so that the current can flow from one pin to another. When the temperature around the thermal fuse rises to its operating temperature, its fusible alloy melts and shrinks into a ball attached to the ends of the two pins under the action of surface tension and the help of special resin. Op deze manier, het circuit is permanent afgesloten.

The following items must be followed to ensure the normal operation of the thermal fuse:

i) Each thermal fuse has a rated current and voltage, a fusing temperature (Tf), a use temperature (Th), and a maximum temperature (Tm) and must be used within the specified parameters.

ii) When selecting the installation position of the fuse, be careful not to transfer stress to the fuse due to vibration in the finished product and displacement of other accessories.

iii) It should be installed in a place where the temperature will not rise above the maximum use temperature after the thermal fuse is blown.

iv) It cannot be used in machines where liquids or humidity are maintained above 95%.

v) The thermal fuse should be installed in a place that can only sense the heat source of the thermal fuse. When it is unavoidable to install a thermal barrier, Bijvoorbeeld, when installing it on a heater, be careful not to connect it directly to prevent the hot wire from heating the temperature fuse.

vi) If the temperature fuse is connected in parallel to increase the current or if overcurrent or overvoltage is continuously passed, the internal contacts of the temperature fuse will be damaged, which will affect its normal operation. Daarom, it cannot be used under the above conditions.

Although the temperature fuse is designed to be highly reliable, the abnormal situations that a single temperature fuse can cope with are limited after all. In addition, if the temperature fuse is damaged and cannot function normally due to human or unpredictable force majeure, the circuit will not be cut off in time when the machine is abnormal. Daarom, when the machine is overheated, when the erroneous action directly affects the human body, when there is no circuit cutting device other than the fuse, and when high safety is required, use more than two temperature fuses with different fusing temperatures.

Functies: Radial and square thermal fuse, thermal cut-off (transparent shell)
Een stuk smeltbare legeringsdraad is aangesloten tussen de twee pinnen van de thermische zekering, die bedekt is met een speciale vierkante schaal van transparante hars. Er kan stroom van de ene pin naar de andere vloeien. Wanneer de temperatuur rond de thermische zekering stijgt tot de ingestelde bedrijfstemperatuur, de smeltbare legeringsdraad smelt en krimpt tot een bolvorm, en wordt met behulp van oppervlaktespanning en speciale hars aan de uiteinden van de twee pinnen bevestigd. Op deze manier, het circuit is permanent afgesloten.

SET thermal fuse

Square thermal fuse size

Dimensies (mm) A B C D E* 5.2±0,5 4.1±0,5 2.3±0.2 0.50±0.05 60±5

Note: The thermal fuse with an operating temperature Tf of 169℃ does not meet environmental protection requirements. If the customer needs, please contact the company’s sales department, thank you!