Commonly used NTC thermistors for air conditioner
There are three types: indoor ambient temperature NTC, indoor coil NTC, and outdoor coil NTC. Higher-end air conditioners also use external ambient temperature NTC, compressor suction and exhaust NTC, 等.
How does the car reflect the temperature of the car engine coolant? It is through the water temperature sensor, which is also called the water temperature sensor plug. So where is the specific location of the car water temperature sensor? The water temperature sensor enables the control unit to identify engine overheating or an unusual rise in temperature. How much does a car water temperature sensor cost?
DS18B20 is a commonly used digital temperature sensor. It outputs digital signals, has the characteristics of small size, low hardware overhead, 抗干擾能力強, 高精度, and is widely used.
DS18B20 is a digital temperature sensor that uses a single bus timing to communicate with the host. Only 1 Wire is needed to complete the temperature data reading;
DS18B20 has a built-in 64-bit product serial number for easy identification. Multiple DS18B20 sensors can be connected to 1 線, and through 64-bit identity authentication, the temperature information collected from different sensors can be read separately.
Today I will show you how to use the DS18B20 digital temperature sensor with an Arduino so you can measure the temperature of air, liquids such as water, and the ground.
To connect the DS18B20 digital temperature sensor to Arduino, you need to do the following steps:
Hardware connection:
Connect the VCC pin of DS18B20 to the 3.3V power pin of Arduino.
Connect the GND pin of DS18B20 to the ground pin of Arduino.
Connect the data pin of DS18B20 to the GPIO pin of Arduino (for example, GPIO4).
Connect a 4.7kΩ pull-up resistor between the data pin and the 3.3V power pin.
High Accuracy and Precision NTC thermistors Sensors are used in various industries, from medical to industrial applications. The medical industry relies on NTC’s in various applications including catheters, dialysis equipment, and patient monitoring. This medical sensor part is 1355 Ohms at 37°C with Beta 25/85 之 3976.
English
العربية
Български
粤语
中文(简体)
中文(漢字)
Nederlands
Suomi
Français
Deutsch
Ελληνικά
Magyar
Italiano
日本語
한국어
Polski
Português
Română
Русский
Slovenščina
Español
Svenska
ภาษาไทย
Türkçe
Tiếng Việt