醫用體腔溫度測量探頭 2.252k 或 10k 歐姆皮膚溫度感測器

醫用溫度感測器, 產品型號齊全, 品質可靠. 1K至680K電阻可選, 使用壽命可達 10 年. 醫療級溫度感測器, 汽車感測器, 家電感測器晶片採用高精度晶片, 反應時間可達 0.5 秒.

JP401 medical body cavity temperature sensor
Product introduction:
JP401 medical body cavity temperature sensor (esophageal/rectal temperature probe) is used for human body cavity temperature measurement. The product nominal resistance value is 2.252kΩ or 10kΩ.

The chip is epoxy encapsulated and can be equipped with a 6.3mm mono audio plug (other plugs can also be equipped according to customer requirements). The measurement temperature tolerance is within (25℃~45℃)±0.1℃, compatible with YSI400 series temperature sensors.

產品特點:
Epoxy resin encapsulation;
Reusable;
測量精度高 (25~45)℃±0.1℃;
Using temperature range 0℃~50℃;

Product application
Used in monitors, suitable for emergency, intensive care units, operating rooms, ETC。, to continuously monitor patient body temperature.

Product structure and size (單元: 毫米)

Medical monitor NTC temperature sensor with 2-pin aviation plug

高準確度 (25℃~45℃) ±0.1℃醫用溫度感測器

帶有 6.3mm 單聲道音訊插頭的醫用體腔溫度感測器

Packing quantity: 1 pcs/packing

6.3mm mono audio plug medical temperature sensor size

預防措施
— Purpose of this product: temperature measurement and control.
— Control the energy dissipation generated by the current flowing through the chip within the required range to avoid measurement errors caused by self-heating of the component.
— If the shrink sleeve is heated at the temperature sensing head, the air outlet of the welding gun should be more than 30mm away from the temperature sensing head to avoid excessive thermal shock of the resistor body caused by high temperature, resulting in resistance drift.
— Storage temperature 0℃～50℃, humidity 30%~80%RH; avoid storage in an environment with corrosive gas or direct sunlight; after opening the package, it needs to be resealed for storage.
— In view of the structural characteristics of epoxy components, users should avoid excessive stretching and bending forces from the lead wires on the component encapsulation head when using it. If the lead wire needs to be bent, the bending point or force point should be controlled on the lead wire 6mm below the encapsulation head to avoid pulling the chip, causing resistance drift or even open circuit, especially when the component is heated.

服務
1. 您的詢問將在 24 小時;
2. 訓練有素、經驗豐富的員工隨時為您服務.
3. 獨特的設計產品和眾多私模產品等待您的選擇.
4. 嚴格保護您的隱私資訊和您的設計理念.

常問問題

Q1. 我可以訂購 NTC 的樣品嗎, PT100,PT1000, RTD, 和 DS18b20 感測器?
A: 是的, 我們歡迎樣品訂單來測試和檢查質量. 混合樣品是可以接受的.