产品类别
产品标签
双金属片式温控器 ( 热切断开关套件, 卡扣盘热开关套件) 当烘干机上限时,防止烘干机过热 热开关在闭路条件下失效. This part Cut-Off Circuit when the heater housing does not have adequate airflow through it; this is normally caused by restriction in the exhaust vent, plugged lint screen, or broken blower wheel. If this part fails, the dryer may not produce any heat. This kit includes one snap disc Thermal switch with a limit of 250 degrees Fahrenheit, and one thermal cut-off fuse. jumper wires, and new female spade terminals Wire harness . Both components are mounted on the heater housing, and measure approximately 2 inches long and 1.5 inches wide each. This Thermal Cut-Off comes in silver and is constructed of metal.
技术参数
1. 电气参数: 1) CQC, VDE, UL, 中性粒细胞? 交流250V 50 ~60Hz 5A / 10A / 15A (阻性负载)
2) UL 交流 125V 50Hz 15A (阻性负载)
2. 工作温度范围: 0 ~ 240 °C (选修的), 温度精度: ± 2 ± 3 ± 5 ± 10 °C
3. The difference between recovery and action temperature: 8 ~ 100 ℃ (选修的)
4. 接线方式: plug-in terminal 250 # (optional bend 0 ~ 90 °); plug-in terminal 187 # (optional bend 0 ~ 90 °, 厚度 0.5, 0.8毫米可选)
5. 使用寿命: ≥100,000次
6. 电气强度: 交流50Hz 1800V 1分钟, 无闪烁, 没有故障
7. 接触电阻: ≤50mΩ
8. 绝缘电阻: ≥100MΩ
9. 联系表: 常闭: 温升, 联系人开放, 温度下降, 联系人开放;
通常开放: Temperature rises, contacts turn on, 温度下降, contacts turn off
10. Enclosure protection level: 防护等级00
11. 接地方式: Connected to the grounded metal parts of the device through the thermostat metal case.
12. 安装方法: It can be directly reinforced by the mother.
13.Temperature working range: -25 ℃℃ + 240 ℃ + 1 ℃ ∽2 ℃
特征
具有性能稳定的特点, 高精度, 小尺寸, 轻的, 高可靠性, 长寿, and little concern for radio.

Bimetal thermal protection

Reset Snap Disc Thermostat

干燥机热切断开关
联系我们
等待您的电子邮件, 我们将在短时间内回复您 12 小时提供您需要的有价值的信息.